RAM 2500 Truck 4WD L6-5.9L DSL Turbo VIN 7 (2001)
16. Remove rear pinion bearing with Puller C-293-PA and Adapters C-293-40 (Fig. 54).
17. Remove pinion depth shims from pinion shaft and record thickness.
INSTALLATION
NOTE: Pinion depth shims are placed between the rear pinion bearing cone and pinion gear to achieve proper ring and pinion gear mesh. If ring and
pinion gears are reused, the original pinion depth shim can be used. Refer to Adjustments (Pinion Gear Depth) to select the proper shim thickness if
ring and pinion gears are replaced.
1. Apply Mopar Door Ease stick lubricant to outside surface of bearing cups.
2. Install rear pinion bearing cup with Installer D-146 and Handle C-4171 (Fig. 55) and verify cup is seated.
