RAM 2500 Truck 4WD L6-5.9L DSL Turbo VIN 7 (2001)
5. If the rotating torque is to low, use Holder 6719 to hold the pinion yoke (Fig. 36), and tighten the pinion shaft nut in 6.8 Nm (5 ft. lbs.) until
proper rotating torque is achieved.
6. Align the installation reference marks and attach the propeller shaft to the yoke.
7. Check and add lubricant to axle, if necessary. Refer to Lubricant Specifications in this section for lubricant requirements.
8. Install brake rotors and calipers.
9. Install wheel and tire assemblies.
10. Lower the vehicle.
