RAM 2500 Truck 4WD L6-5.9L DSL Turbo VIN 7 (2001)
10. Rotate the pinion shaft using an inch pound torque wrench. Rotating resistance torque should be equal to the reading recorded, plus a small amount
for the drag the new seal will have (Fig. 25).
NOTE: The bearing rotating torque should be constant during a complete revolution of the pinion. If the rotating torque varies, this indicates a
binding condition.
11. Install the propeller shaft with the installation reference marks aligned.
12. Tighten the universal joint yoke clamp screws to 19 Nm (14 ft. lbs.).
13. Install the brake drums.
14. Add gear lubricant to the differential housing, if necessary. Refer to the Lubricant Specifications for gear lubricant requirements.
15. Install wheel and tire assemblies and lower the vehicle.
