RAM 2500 Truck 4WD L6-5.9L DSL Turbo VIN 7 (2001)
6. Remove companion flange rubber seal from front output shaft (Fig. 99).
7. Remove seal from front case with pry tool (Fig. 100).
INSTALLATION
1. Install new front output seal in front case with Installer Tool 8143-A as follows:
a. Place new seal on tool. Garter spring on seal goes toward interior of case.
b. Start seal in bore with light taps from hammer (Fig. 101). Once seal is started, continue tapping seal into bore until installer tool seats against
case.
