RAM 2500 Truck 4WD L6-5.9L DSL Turbo VIN 7 (2001)
Actuator: Service and Repair
Front Axle - 248FBI
REMOVAL
1. Disconnect the vacuum and wiring connector from the shift housing.
2. Remove indicator switch.
3. Remove shift motor housing cover, gasket and shield from the housing (Fig. 28).
DISASSEMBLY
1. Remove E-clips from the shift motor housing and shaft. Remove shift motor and shift fork from the housing (Fig. 29).
2. Remove O-ring seal from the shift motor shaft.
3. Clean and inspect all components. Replaced any component that is excessively worn or damaged.
ASSEMBLY
1. Install a new O-ring seal on the shift motor shaft.
2. Insert shift motor shaft through the hole in the housing and shift fork. The shift fork offset should be toward the differential.
