RAM 2500 Truck 4WD L6-5.9L DSL Turbo VIN C (2004)
SPECIAL TOOLS/EQUIPMENT REQUIRED:
NOTE:
An updated J1962 cable has been released. This cable has a red colored connector at the DRBIII(R) connection. Use this cable whenever a flash is
being performed.
POLICY:
Reimbursable within the provisions of the warranty.
TIME ALLOWANCE:
FAILURE CODE:
Disclaimer
This bulletin is supplied as technical information only and is not an authorization for repair.
Repair Procedure
NOTE:
Whenever a controller is programmed, the software in the DRBIII(R) must be programmed with the latest revision level available.
NOTE:
If this flash process is interrupted/aborted, the flash should be restarted and then follow the directions on the DRBIII(R).
1.
With the ignition switch in the "RUN" position, determine and record the "ECM part number" of the ECM currently in the vehicle. Using the
DRBIII(R) select:
a.
"DRBIII(R) Standalone"
b.
"1998 - 2004 Diagnostics"
c.
"All (Except Below)"
d.
"Engine"
e.
On 1998-1/2 - 2003 vehicles, select "Cummins". 2004 and later vehicles, proceed to next step.
f.
"Module Display"
g.
Record the first (10) characters of the "ECM part number" on the repair order for later reference.
