RAM 2500 Truck 4WD L6-5.9L DSL Turbo VIN C (2004)
g. CM84X Check VIN
h. Follow the directions on the DRBIII(R) screen. When the process is complete, proceed to next step.
NOTE:
Due to the Cummins controller programming procedure, a DTC may be set in other modules (PCM, TCM, BCM, MIC, SKIM, etc.) within the
vehicle, if so equipped. Some DTC's may cause the MIL to illuminate. Check all modules using "Module Scan", record the DTC's, and erase these
DTC's prior to returning the vehicle to the customer. Erase any DTC's in the PCM only after all other modules have had their DTC's erased.
NOTE:
The following step is required by law.
20. Type the necessary information on the Authorized Modification Label p/n 04275086AB and attach near the VECI label
REPAIR PROCEDURE 2006 -2007 MY - USING WiTECH DIAGNOSTIC APPLICATION:
NOTE:
HELP USING THE wiTECH DIAGNOSTIC APPLICATION FOR FLASHING AN ECU IS AVAILABLE BY SELECTING "HELP" THEN
"HELP CONTENTS" AT THE TOP OF THE wiTECH DIAGNOSTIC APPLICATION WINDOW.
NOTE:
If this flash process is interrupted/aborted, the flash should be restarted.
1. Reprogram the PCM with the latest software. Follow the detailed service procedures available in DealerCONNECT/TechCONNECT, Refer To
Group 8 - Electrical > 8E - Electronic Control Modules - Service Information > Module - Engine Control, Diesel > Standard Procedure > PCM/ECM
Reprogramming - Diesel.
2. Type the necessary information on the "Authorized Modification Label" and attach it near the VECI label.
Diagnostic procedures for these new DTC's are included in this Service Bulletin on the last 2 pages which may be printed.
POLICY:
Reimbursable within the provisions of the warranty.
TIME ALLOWANCE:
