RAM 2500 Truck 4WD L6-6.7L DSL Turbo VIN A (2007)
Wheel Speed Sensor: Service and Repair
Sensor-Wheel Speed-ABS-Rear
Removal
REMOVAL
1. Raise the vehicle on a hoist.
2. Remove the brake line mounting nut and remove the brake line from the sensor stud.
3. Remove the mounting stud (2) from the sensor and shield.
4. Remove the sensor (1) and shield from the differential housing (3).
5. Disconnect the sensor wire harness and remove the sensor (1).
Installation
INSTALLATION
1. Connect the harness to the sensor. Be sure the seal is securely in place between the sensor and the wiring connector.
2. Install the O-ring on the sensor (if removed).
3. Insert the sensor (1) in the differential housing (3).
4. Install the sensor shield.
5. Install the sensor mounting stud (2) and tighten to 24 Nm (200 in. lbs.).
6. Install the brake line on the sensor stud (2)and install the nut.
7. Lower the vehicle.
Removal
REMOVAL
