RAM 2500 Truck 4WD L6-6.7L DSL Turbo VIN A (2007)
Compass: Removal and Replacement
Compass Mini - Trip Computer
COMPASS MINI - TRIP COMPUTER
1. Disconnect and isolate the battery negative cable.
2. Remove the overhead console (3) from the headliner.
3. Remove the screws (1) that secure the Compass Mini - Trip Computer (CMTC) (4) to the overhead console housing (3).
4. Remove the CMTC (4) from the overhead console housing (3).
Bulb - CMTC Control
BULB - CMTC CONTROL
WARNING: To avoid serious or fatal injury on vehicles equipped with airbags, disable the supplemental restraint system before attempting
any steering wheel, steering column, airbag, seat belt tensioner, impact sensor, or instrument panel component diagnosis or service. Disconnect
and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge before performing further
diagnosis or service. This is the only sure way to disable the supplemental restraint system. Failure to take the proper precautions could result
in accidental airbag deployment.
NOTE: There are provisions for up to three bulb/bulb holder units on the Compass Mini-Trip Computer (CMTC) circuit board. The two outboard bulbs
illuminate the CMTC push buttons, while the center bulb illuminates the optional universal transmitter push buttons. Therefore, the center bulb location
is only populated on vehicles equipped with the optional universal transmitter.
1. Disconnect and isolate the battery negative cable.
