RAM 2500 Truck 4WD L6-6.7L DSL Turbo VIN A (2007)
16. Position the rear section of the A/C liquid line (2) into the engine compartment.
17. Remove the tape or plugs from the opened ends of the A/C liquid lines and the evaporator tube (4).
18. Lubricate new O-ring seals with clean refrigerant oil and install them onto the rear liquid line spring-lock coupler fitting. Use only the specified
O-ring seals as they are made of a special material for the R-134a system. Use only refrigerant oil of the type recommended for the A/C
compressor in the vehicle.
19. Connect the rear section of the A/C liquid line to the evaporator tube.
20. Install the secondary retaining clip (3) onto the spring-lock coupler that secures the rear section of the A/C liquid line onto the evaporator tube.
21. Engage the A/C liquid line into the body retaining clip (5).
22. Lubricate new O-ring seals with clean refrigerant oil and install them onto the front liquid line spring-lock coupler fitting. Use only the specified
seals as they are made of a special material for the R-134a system. Use only refrigerant oil of the type recommended for the A/C compressor in the
vehicle.
23. Connect the rear section of the A/C liquid line (6) to the front section of the liquid line.
24. Install the secondary retaining clip (1) onto the spring-lock coupler that secures the front section of the A/C liquid line to the rear section of the
liquid line.
25. Install the passenger side battery tray.
26. Reconnect the negative battery cables.
27. Evacuate the refrigerant system.
28. Adjust the refrigerant oil level.
29. Charge the refrigerant system.
