RAM 2500 Truck 4WD L6-6.7L DSL Turbo VIN A (2007)
Fuel Level Sensor: Service and Repair
Removal
REMOVAL
1. Drain and remove fuel tank.
2. Note rotational position of module before attempting removal. An indexing arrow is located on top of module for this purpose.
3. Position Special Tool 9340 (3) into notches on outside edge of lockring (5).
4. Install 1/2 inch drive breaker bar (1) to tool 9340 (3).
5. Rotate breaker bar counterclockwise to remove lockring.
6. Remove lockring. The module will spring up slightly when lockring is removed.
7. Remove module from fuel tank. Be careful not to bend float arm while removing.
