RAM 2500 Truck 4WD L6-6.7L DSL Turbo VIN A (2007)
12. USING TOOL #9010:
a. Special Tool #9010 is equipped with 2 clamshell clamps, a sliding retainer sleeve to retain the clamshell clamps, a 2-piece mounting stud, and
a pivoting handle. Do not attempt to remove the fuel injector with any other device. Damage to injector will occur.
b. The rocker housing is bolted to the top of cylinder head. The mounting stud from tool #9010 was meant to temporarily replace a rocker
housing mounting bolt. Remove the necessary rocker housing mounting bolt. These mounting bolts are located at the center of each of the 5
rocker housing support bridges.
c. Install and tighten 2-piece mounting stud to rocker housing. If removing the No. 6 fuel injector, separate the 2-piece mounting stud. Install
lower half of mounting stud to center of rocker housing bridge. Install upper half of mounting stud to lower half.
d. Position tool handle to mounting stud and install handle nut. Leave handle nut loose to allow a pivoting action.
e. Position lower part of clamshell halves to sides of fuel injector (wider shoulder to bottom). The upper part of clamshell halves should also be
positioned into machined shoulder on the handles pivoting head.
f.
Slide the retainer sleeve over pivoting handle head to lock clamshell halves together.
g. Be sure handle pivot nut is loose.
h. Depress handle downward to remove fuel injector straight up from cylinder head bore.
13. Remove and discard injector sealing washer (2). This washer (2) should be located on tip of injector, or may have remained in the injector bore.
