RAM 2500 Truck 4WD L6-6.7L DSL Turbo VIN A (2007)
Clutch Pedal Position Sensor / Switch: Testing and Inspection
SWITCH-CLUTCH PEDAL POSITION
1. Disconnect switch 2-wire connector (2) attached to pedal support bracket (1), under instrument panel to left of clutch pedal.
2. Check switch continuity with an ohmmeter while operating clutch pedal.
-
Pedal Depressed - Continuity
-
Pedal Released - No Continuity
3. If continuity is not present or always present, replace clutch master cylinder. Switch is not serviced separately.
