RAM 2500 Truck 4WD L6-6.7L DSL Turbo VIN A (2007)
Ball Joint: Service and Repair
Front - Link/Coil
Removal
REMOVAL
1. Remove the steering knuckle.
2. Remove the axle shaft from the axle.
3. Remove lower snap ring from the lower ball joint.
4. Position special tool 8975-2 (RECEIVER) (2) and 8975-4 (DRIVER) (4) with tool C4212-F (PRESS)(1) as shown to remove lower ball stud.
Installation
INSTALLATION
1. Position special tool 8975-1 (DRIVER) (2) and 8975-3 (RECEIVER) (5) with C4212-F (PRESS)(1) as shown to install lower ball stud (3).
2. Install the axle shaft into the axle.
3. Install the steering knuckle.
