RAM 2500 Truck 4WD L6-6.7L DSL Turbo VIN A (2007)
Seals and Gaskets: Service and Repair
48RE Automatic Transmission
Removal
REMOVAL
1. Raise vehicle.
2. Mark propeller shaft and axle yoke for alignment reference.
3. Disconnect and remove propeller shaft.
4. Remove old seal with a screw mounted in a slide hammer.
Installation
INSTALLATION
1. Place seal in position on overdrive housing.
2. Drive seal into overdrive housing with Seal Installer 8154 (1) or 9037 (1) if equipped with a dust boot and Handle C-4171.
3. Carefully guide propeller shaft slip yoke into housing and onto output shaft splines. Align marks made at removal and connect propeller shaft to
rear axle pinion yoke.
