RAM 2500 Truck 4WD L6-6.7L DSL Turbo VIN A (2007)
NOTE: Axle flange bolts must be replaced or cleaned existing bolts apply Mopar(R) Lock N' Seal or Loctite(R) 242 on the threads.
1. Clean axle flange and hub.
2. Install new axle shaft gasket.
3. Slide axle shaft into the axle tube.
4. Install axle shaft flange (1) bolts (2) and tighten to 129 Nm (95 ft. lbs.).
Removal
REMOVAL
1. Remove axle shaft flange (1) bolts (2).
2. Slide axle shaft out of the axle tube.
3. Remove axle shaft gasket.
Installation
INSTALLATION
NOTE: Axle flange bolts must be replaced or use Mopar(R) Lock N' Seal or Loctite(R) 242 on cleaned existing bolts.
