RAM 2500 Truck 4WD L6-6.7L DSL Turbo VIN A (2007)
8. Tilt inner race/hub (1) and cage (3) and install the balls(4).
9. Place new clamps onto new boot and slide boot onto the shaft to it's original position.
10. Apply the rest of grease to the C/V joint and boot.
11. Install the joint onto the shaft (2). Push the joint onto the shaft until the snap ring (1) seats in the groove (3).
NOTE: Pull on the joint to verify the span ring has engaged.
12. Position the boot on the joint in it's original position.
NOTE: Verify boot is not twisted and remove any excess air.
13. Secure both boot (5) clamps (2) (4) with Clamp Installer C-4975A. Place tool on clamp bridge and tighten tool until jaws of the tool are closed.
