RAM 2500 Truck 4WD L6-6.7L DSL Turbo VIN A (2007)
5. Install Receiver 8498 (1) into the adjuster bore.
6. Install Extractor Rod 6310 with Extractor Foot 6310-9 (2) through the receiver and axle seal.
7. Install Extractor Plate 6310-2 and Nut 6310-7 (2) on the extractor rod (1).
8. Tighten nut (2) on extractor rod (1) to pull seal into the receiver.
Installation
INSTALLATION
1. Install axle seal on Installer Cups 8885-2 (1) (3) and position cups with seals into the housing.
NOTE: Seals are installed with the axle guide facing outward.
