RAM 2500 Truck 4WD V10-8.0L VIN W (1997)
Driver/Vehicle Information Display: Service and Repair
Message Center
REMOVAL
1. Remove the cluster bezel.
Message Center And Heater-A/C Control Remove/Install
2. Remove the four screws that secure the message center/heater-A/C control to the instrument panel.
3. Pull the message center and heater-A/C control assembly away from the instrument panel far enough to access the wire harness connectors.
Message Center And Heater-A/C Control Connectors
4. Unplug the two wire harness connectors and the vacuum harness connector from the rear of the message center and heater-A/C control assembly.
5. Push in on the red temperature control cable retainer flag to release it from the heater-A/C control housing. Remove the cable end from the
heater-A/C control unit.
6. Remove the message center and heater-A/C control assembly from the instrument panel.
7. Reverse the removal procedures to install.