RAM 2500 Truck 4WD V10-8.0L VIN W (1997)
Caliper Replacement
5. Rotate caliper rearward off rotor and out of steering knuckle support ledges.
6. Remove front brake hose fitting bolt completely and remove caliper and brake shoes as assembly.
7. Cover open end of front brake hose fitting to prevent dirt entry.
Installation
INSTALLATION
1. Clean caliper and steering knuckle slide surfaces with wire brush. Then apply coat of silicone base to slide surfaces.
2. Install caliper over rotor and seat it on steering knuckle mounting arms.
3. Start caliper mounting bolts by hand to avoid cross threading. Then tighten mounting bolts to 51 Nm (38 ft. lbs.).
Front Brake Hose Attachment
