RAM 2500 Truck 4WD V10-8.0L VIN W (1997)
Installing Dust Boot
7. Lightly lubricate lip of new boot with silicone grease. Install boot on piston and work boot lip into the groove at the top of piston.
8. Stretch boot rearward to straighten boot folds, then move boot forward until folds snap into place.
9. Install new piston seal into caliper bore. Be sure square cut seal is fully seated and is not twisted.
10. Install piston into caliper bore. Once piston is started into the piston seal, press piston 3/4 of way down into the caliper bore by hand or with
hammer handle.
Fig. 15 Caliper Dust Boot Installation
11. Seat dust boot in caliper installer 6754, or equivalent.
12. Press piston to the bottom of the caliper bore.
13. Lubricate caliper mounting bolts, collars, bushings and bores with silicone grease.
