RAM 2500 Truck 4WD V10-8.0L VIN W (1997)
7. Bleed new valve assembly at each brake line fitting one at a time. Remember to close valve bleed plug before each brake pedal stroke.
Continue bleeding until fluid flowing from fittings is clear and free of bubbles.
8. Remove depressor tool from valve stem and install cap on stem. Then tighten bleed plug to 7-9 Nm (60-84 inch lbs.).
ORIGINAL VALVE
If original assembly is being used, bleed plug and bleed valve do not have to be open during bleeding operations. Just bleed the valve assembly at
each brake line fitting one at a time Bleed first wheel brake unit. Start at left rear wheel and follow sequence recommended. Repeat bleeding
operation at each wheel until fluid coming out of bleed screw is clear and free of bubbles. Top off master cylinder reservoir fluid level. Then verify
proper brake operation before moving vehicle.
Rear Antilock Valve Replacement
Valve Harness
REMOVAL
1. Disconnect ground wire and harness wires from combination valve switch and Rear Wheel Antilock Brakes (RWAL) valve.
Master Cylinder Brake Lines
2. Disconnect lines to front and rear brakes from RWAL and combination valves.
3. Remove brake lines connecting master cylinder to combination valve.
4. Remove nuts attaching master cylinder and combination valve bracket to booster studs.
5. Remove master cylinder.
6. Remove combination valve, valve bracket and RWAL valve as assembly.
7. Remove brake line connecting combination valve to RWAL valve.
