RAM 2500 Truck 4WD V10-8.0L VIN W (1997)
NOTE: If new booster is being installed, check code letters to verify that correct booster is being installed.
INSTALLATION
1. Position booster on engine compartment dash panel.
2. Install and tighten booster mounting stud nuts to 23-34 Nm (17-25 ft. lbs.).
3. Connect booster push rod to brake pedal.
4. Install knee bolster.
5. Connect vacuum hose to booster check valve.
6. Install master cylinder and valves on booster as assembly: and tighten mounting nuts to 23-34 Nm (17-25 ft. lbs.).
7. Connect front/rear brake lines to combination valve and RWAL valve. Tighten brake line fittings to 16-23 Nm (12-17 ft. lbs.).
8. Connect harness wires to RWAL valve and pressure differential switch on combination valve.
9. Fill and bleed brake system. See: Brake Bleeding/Service and Repair
