Removal of Timing Cover for RAM 2500 Truck 4WD V10-80L VIN W (1997)
Timing Cover: Service and Repair
Removal
1. Disconnect the negative cable from the battery.
2. Drain cooling system.
3. Remove the serpentine belt.
4. Remove fan shroud.
5. Remove fan.
6. Unbolt A/C compressor and set on top of engine.
7. Remove generator, air pump, and bracket assembly.
8. Remove water pump. Refer to Cooling System.
9. Using a 3-prong puller to remove pulley/damper from the crankshaft.
10. Loosen oil pan bolts and remove the front oil pan bolts that mount the pan to the timing chain cover.
11. Remove the cover bolts.
12. Remove timing chain cover and gasket using extreme caution to avoid damaging oil pan gasket.
13. Inspect surface of cover. Remove any burrs or high spots.