RAM 2500 Truck 4WD V10-8.0L VIN W (1997)
Blower Motor Resistor: Service and Repair
Fig 40 Blower Motor Resistor -- Typical
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Unplug the blower motor resistor wire harness connector.
3. Remove the screws that secure the resistor to the heater-A/C housing.
4. Remove the blower motor resistor.
INSTALLATION
1. Install the blower motor resistor to the heater- A/C housing.
2. Install and tighten the screws that secure the resistor to the heater-A/C housing.
3. Plug the wire harness connector into the resistor.
4. Connect the battery negative cable.