RAM 2500 Truck 4WD V10-8.0L VIN W (1997)
Fig 17 Install Puller Plate
7. Install the puller through-bolts (Special Tool C-6461) through the puller flange and into the jaws of the rotor puller and tighten. Turn the puller
center bolt clockwise until the rotor pulley is free.
Fig 18 Clutch Coil Wire Harness
8. Remove the screw and retainer from the clutch coil wire harness on the compressor front housing.
Fig 19 Clutch Field Coil Snap Ring Removal
9. Remove the snap ring from the compressor hub and remove the clutch field coil.
