RAM 2500 Truck 4WD V10-8.0L VIN W (1997)
Compressor Clutch Coil: Testing and Inspection
NOTE: The battery must be fully-charged before performing the following tests.
1. Connect an ammeter (0 to 10 ampere scale) in series with the clutch coil terminal. Use a voltmeter (0 to 20 volt scale) with clip-type leads for
measuring the voltage across the battery and the compressor clutch coil.
2. With the heater-A/C mode control switch in any A/C mode, and the blower motor switch in the lowest speed position, start the engine and run it at
normal idle.
3. The compressor clutch coil voltage should read within two volts of the battery voltage. If there is voltage at the clutch coil, but the reading is not
within two volts of the battery voltage, test the clutch coil feed circuit for excessive voltage drop and repair as required. If there is no voltage
reading at the clutch coil, refer to the proper Powertrain Management/Computers and Control Systems/ Diagnostic Procedures for testing of the
compressor clutch circuit.
The following components must be checked and repaired as required before you can complete testing of the clutch coil:
-
Fuses in the fuse block module and the Power Distribution Center
-
Heater-A/C mode control switch
-
Compressor clutch relay
-
High pressure cut-off switch
-
Low pressure cycling clutch switch
-
Powertrain Control Module.
4. The compressor clutch coil is acceptable if the current draw measured at the clutch coil is 2.0 to 3.9 amperes with electrical system voltage at 11.5
to 12.5 volts. This should only be checked with the work area temperature at 21 °C (70 °F). If system voltage is more than 12.5 volts, add
electrical loads by turning on electrical accessories until the system voltage drops below 12.5 volts.
a. If the clutch coil current reading is 4 amperes or more, the coil is shorted and should be replaced.
b. If the clutch coil current reading is zero, the coil is open and should be replaced.
