RAM 2500 Truck 4WD V10-8.0L VIN W (1997)
Low Pressure Sensor / Switch: Service and Repair
Fig 25 High Pressure Cut-off Switch -- Typical
HIGH PRESSURE CUT-OFF SWITCH
Removal
1. Disconnect and isolate the battery negative cable.
2. Unplug the wire harness connector from the switch.
3. Unscrew the switch from the discharge line fitting.
Installation
1. Install and tighten the switch.
2. Unplug the wire harness connector into the switch.
3. Connect the battery negative cable.
Fig 28 Low Pressure Cycling Clutch Switch
LOW PRESSURE CYCLING CLUTCH SWITCH
1. Disconnect and isolate the battery negative cable.
2. Unplug the wire harness connector from the switch on the top of the accumulator.
3. Unscrew the switch from the fitting on the accumulator.
4. Reverse the removal procedures to install.
