RAM 2500 Truck 4WD V10-8.0L VIN W (1997)
Turn Signal Flasher: Service and Repair
REMOVAL and INSTALLATION
1. Disconnect and isolate the battery negative cable.
Hazard Warning Or Turn Signal Flasher Remove/Install
2. Open the driver door and remove the snap-in fuseblock module cover on the left end of the instrument panel.
3. Unplug the flasher from the fuseblock module.
4. Install the flasher by aligning the flasher terminals with the cavities in the fuseblock module and pushing the flasher firmly into place.
5. Install the fuseblock module cover.
6. Connect the battery negative cable.
7. Test the flasher operation.
