RAM 2500 Truck 4WD V10-8.0L VIN W (1997)
CAUTION: Whenever the fuel pump module is serviced, the rubber gasket must be replaced.
INSTALLATION
1. Using a new gasket position fuel pump module into opening in fuel tank.
2. Position locknut over top of fuel pump module. Install locknut finger tight.
3. Rotate module until positioned as shown.
-
This step must be performed to prevent float from contacting side of fuel tank.
-
Be sure fuel filter/fuel pressure regulator is pointed to drivers side of vehicle.
4. Install Special Tool 65-56 to locknut.
5. Tighten locknut to 24-44 N.m ( 18-32 ft. lbs) torque.
6. Install fuel tank.
-
Refer to Fuel Tank Removal/Installation.
