RAM 2500 Truck 4WD V10-8.0L VIN W (1997)
Headlamp Switch: Testing and Inspection
The content of this article reflects changes called for in TSB 26-01-97.
WARNING: ON VEHICLES EOUIPPED WITH AIRRAG REFER TO Restraint Systems / Air Bag Systems BEFORE ATTEMPTING ANY
STEERING WHEEL, STEERING COLUMN, OR INSTRUMENT PANEL COMPONENT DIAGNOSIS OR SERVICE. FAILURE TO TAKE
THE PROPER PRECAUTIONS COULD RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT AND POSSIBLE PERSONAL INJURY
See: Restraint Systems/Air Bag Systems
1. Disconnect and isolate the battery negative cable. Remove the headlamp switch from the instrument panel. See: Service and Repair
Unplug the headlamp switch wire harness connectors. Open the driver door. Check for continuity between the left front door jamb switch sense
circuit cavity of the headlamp switch wire harness connector and a good ground There should be continuity with the driver door open and no
continuity with the driver door closed. If OK go to (2). If not OK repair the circuit to the driver door jamb switch as required.
2. Unplug the buzzer module from the fuseblock module. Check for continuity between the key-in ignition switch sense circuit cavities of the
headlamp switch wire harness connector and the buzzer module receptacle in the fuseblock module. There should be continuity. If OK go to
(3). If not OK repair the open circuit to the buzzer module as required.
3. Check for continuity between the left front door jamb switch sense circuit and the key-in ignition switch sense circuit terminals of the
headlamp switch. There should be no continuity with the switch in the Off position and continuity with the switch in the park or headlamps On
position. If not OK replace the faulty headlamp switch.
