RAM 2500 Truck 4WD V10-8.0L VIN W (1997)
6. Install dust seal with a driver and handle.
7. Install pitman shaft to side cover by screwing shaft in until it fully seats to side cover.
8. Install preload adjuster nut. Do not tighten nut until after Over-Center Rotation Torque adjustment has been made.
9. Install gasket to side cover and bend tabs around edges of side cover.
10. Install pitman shaft assembly and side cover to housing.
11. Install side cover bolts and tighten to 60 Nm (44 ft. lbs.).
12. Adjust Over-Center Rotation Torque.
Spool Valve
The content of this article reflects changes called for in TSB 26-01-97.
DISASSEMBLY
1. Remove lock nut.
2. Remove adjuster nut with Spanner Wrench C-4381, or equivalent.
3. Remove thrust support assembly out of the housing.
4. Pull stub shaft and valve assembly from the housing.
