RAM 2500 Truck 4WD V10-8.0L VIN W (1997)
Rotor Hub/Bearing Removal
NOTE: If rotor hub assembly will not come out of the knuckle, use Puller C-844 with extra Puller Leg C-844-1, or equivalents to remove the
assembly.
Rotor And Hub/Bearing
9. Press out the wheel studs/hub extension studs and separate the rotor from the hub.
Wheel Speed Sensor
10. Remove the wheel speed sensor from the hub bearing if equipped.
INSTALLATION
1. Install the wheel speed sensor in the hub bearing if equipped.
2. Position rotor on the hub/bearing.