RAM 2500 Truck 4WD V10-8.0L VIN W (1997)
Band: Adjustments
FRONT BAND ADJUSTMENT
The front (kickdown) band adjusting screw is located on the left side of the transmission case above the manual valve and throttle valve levers.
1. Raise vehicle.
2. Loosen band adjusting screw locknut. Then back locknut off 3-5 turns. Be sure adjusting screw turns freely in case. Apply lubricant to screw
threads if necessary.
3. Tighten band adjusting screw to 8 Nm (72 inch lbs.) torque with Inch Pound Torque Wrench C-3380-A, or equivalent, a 3-inch extension and
5/16 socket.
-
Back off front band adjusting screw 2-7/8 turns for 46RE Transmission (V-8 Models)
-
Back off front band adjusting screw 1-7/8 turns for 47RE Transmission (V-10 and Diesel Models).
-
Hold adjuster screw in position and tighten locknut to 41 Nm (30 ft. lbs.) torque.
CAUTION: If Adapter C-3705, or equivalent is needed to reach the adjusting screw, tighten the screw to only 5 Nm (47 - 50 inch lbs.) torque.
4. Lower vehicle.
REAR BAND ADJUSTMENT
The transmission oil pan must be removed for access to the rear band adjusting screw.
