RAM 2500 Truck 4WD V10-8.0L VIN W (1997)
Pinion Gear: Service and Repair
Rear Differential
With 248 or 267 Differential
NOTE: The ring and pinion gears are service in a matched set. Do not replace the pinion gear without replacing the ring gear.
REMOVAL
1. Remove differential assembly from axle housing.
2. Mark pinion yoke and propeller shaft for installation alignment.
3. Disconnect propeller shaft from pinion yoke. Using suitable wire, tie propeller shaft to underbody.
4. Using Yoke Holder 6719, or equivalent to hold yoke, remove the pinion yoke nut and washer.
5. Using Remover C-452 and Wrench C-3281, or equivalents, remove the pinion yoke from pinion shaft.
6. Remove the pinion gear from housing. Catch the pinion with your hand to prevent it from falling and being damaged.
7. Remove the pinion seal with a slide hammer or suitable pry bar.
8. Remove oil slinger, if equipped, and the front pinion bearing.
