RAM 2500 Truck 4WD V10-8.0L VIN W (1997)
c. Remove installer and verify that seal is recessed the proper amount. Seal should be 2.03 to 2.5 mm (0.080 to 0.100 inch) below top edge of
seal bore in front case. This is correct final seal position.
CAUTION: Be sure the front output seal is seated below the top edge of the case bore as shown. The seal could loosen, or become cocked if not
seated to recommended death.
2. Install companion flange seal on front shaft.
3. Install companion flange on front shaft. Then install and tighten flange nut to 176 - 271 Nm (130 - 200 ft. lbs.) torque.
