RAM 2500 Truck 4WD V10-8.0L VIN W (1997)
Power Window Regulator Remove
12. Remove the power window regulator and motor as a unit from the door.
13. To install, place the power window regulator and motor as a unit inside the door and slide the two loose front regulator screws into the slotted
holes in the door.
14. Install the four remaining screws that secure the regulator and track to the inner door panel.
15. Tighten the regulator screws to 12 N.m (105 in.lbs.).
16. Move the glass as far rearward into the channel as possible and push down. Tighten the two window track screws to 12 N.m (105 in. lbs.).
17. Secure the door glass to the regulator by sliding the two channel nuts into the slotted holes in the regulator arm. Tighten the door glass channel
nuts to 12 N.m (105 in. lbs.).
18. Plug the wire harness connector into the power window motor connector.
19. Using an adhesive/sealant (3M 08041 or 08044 is recommended), install the plastic watershield to the door inner panel.
20. Reverse the remaining removal procedures to complete the installation.
