RAM 2500 Truck 4WD V10-8.0L VIN W HDC (2000)
2. Using a small flat bladed tool, or equivalent, release the upper retaining clips while pulling the ball socket away from the ball stud. (Fig. 5)
CAUTION: Do not pull the supports from the middle while removing.
3. Pulling at the ends only, remove the support cylinder.
INSTALLATION
1. Make sure the retaining clips are seated into the ball socket fully.
CAUTION: Do not install the support cylinders pressing at the center of the cylinder. Press the ends only.
2. Install the support cylinder over the ball studs with the thin end connected to the body side of the hinge and the retaining clips snapping into place.
