RAM 2500 Truck 4WD V10-8.0L VIN W HDC (2000)
Fig. 17
6. Remove the push pin fasteners, if equipped, and remove the back panel trim. (Fig. 16) or (Fig. 17)
INSTALLATION
1. Position the back panel trim behind the right pillar trim.
2. Route the center belt and trim bezel through the back panel, if equipped.
3. On standard cab models, install the left lower b-pillar trim panel.
4. On quad cab models, install the left lower c-pillar trim panel.
5. Position the center belt trim bezel, if equipped, and seat the attachment clips fully.
6. Install the utility hooks/bin latch and screws, if equipped.
7. Install the child seat tethers, if equipped.
Rear Door Scuff Plate
REAR DOOR SILL TRIM COVER
REMOVAL
Fig. 21
1. Using a trim stick C-4755 or equivalent, pry up the sill trim and remove. (Fig. 21)
INSTALLATION
