RAM 2500 Truck 4WD V10-8.0L VIN W HDC (2000)
5. Remove reservoir by rocking it to one side and pulling free of grommets.
Grommet Removal
6. Remove old grommets from cylinder body.
INSTALLATION
CAUTION: Do not use any type of tool to install the grommets. Tools may cut, or tear the grommets creating a leak problem after installation. Install
the grommets using finger pressure only.
1. Lubricate new grommets with clean brake fluid and Install new grommets in cylinder body. Use finger pressure to install and seat grommets.
2. Start reservoir in grommets. Then rock reservoir back and forth while pressing downward to seat it in grommets.
3. Install pins that retain reservoir to cylinder body.
4. Fill and bleed master cylinder on bench before installation in vehicle.
