RAM 2500 Truck 4WD V10-8.0L VIN W HDC (2000)
8. Connect servo cable to throttle body. Refer to Servo Cable Removal/installation.
9. Install battery tray. Tighten all battery tray mounting hardware to 16 Nm (140 in. lbs.) torque.
10. Position battery into battery tray.
11. If equipped, install battery heat shield.
12. Install battery holddown clamp. Tighten bolt to 4 Nm (35 in. lbs.) torque.
13. Connect positive battery cable to battery.
14. Connect negative battery cable to battery.
15. Before starting engine, operate accelerator pedal to check for any binding.
