RAM 2500 Truck 4WD V10-8.0L VIN W HDC (2000)
Engine Mount: Service and Repair
Front Mount
REMOVAL
1. Disconnect the negative cable from the battery.
2. Position fan to assure clearance for radiator top tank and hose.
CAUTION: DO NOT lift the engine by the intake manifold.
3. Install engine support/lifting fixture.
4. Raise vehicle on hoist.
Fig. 29
5. Lift the engine SLIGHTLY and remove the thru-bolt and nut and rubber engine restrictors. (Fig. 29).
6. Remove engine support bracket/cushion bolts (Fig. 29). Remove the support bracket/cushion and heat shields.
INSTALLATION
1. With engine raised SLIGHTLY, position the engine support bracket/cushion and heat shields to the block. Install new bolts and tighten to 81 Nm
(60 ft. lbs.) torque.
2. Install the thru-bolt and 2 piece rubber engine rubber restrictors onto the engine support bracket/cushion.