RAM 2500 Truck 4WD V10-8.0L VIN W HDC (2000)
Fig. 50 Throttle Cable At Throttle Body
6. Remove the throttle cable socket at throttle lever ball.(Fig. 50) (snaps off).
Fig. 51 Cable Release Tab (Typical)
7. Remove cable housing at throttle body mounting bracket by pressing on release tab with a small screwdriver (Fig. 50) or (Fig. 51). To prevent
cable housing breakage, press on the tab only enough to release the cable from the bracket. Lift the cable housing straight up from bracket while
pressing on release tab. Remove throttle cable from vehicle.
INSTALLATION
1. In this Engine:
a. Connect cable and socket to throttle body lever ball (snaps on) (Fig. 50).
b. Connect cable to throttle body mounting bracket (push down and lock).
2. Install the remaining cable housing end into and through the dash panel opening (snaps into position). The two plastic pinch tabs (Fig. 47) should
lock the cable to dash panel.
