RAM 2500 Truck 4WD V10-8.0L VIN W HDC (2000)
Suspension Strut / Shock Absorber: Service and Repair
Front
REMOVAL
1. Remove the nut retainer and grommet from the upper stud in the engine compartment.
2. Remove three nuts from the upper shock bracket.
3. Remove the lower bolt from the axle bracket. Remove the shock absorber from engine compartment.
INSTALLATION
1. Position the lower retainer and grommet on the upper stud. Insert the shock absorber through the spring from engine compartment.
2. Install the lower bolt and tighten to 135 Nm (100 ft. lbs.).
3. Install the upper shock bracket and three nuts. Tighten nuts to 75 Nm (55 ft. lbs.).