RAM 2500 Truck 4WD V10-8.0L VIN W HDC (2000)
3.
Pry the gear shift rod vertical link adjuster block from the torque shaft lever (Fig. 1). Inspect the plastic grommet. If any damage is present, replace
the grommet.
4.
Remove the three screws that attach the torque shaft to the floor pan support.
5.
Remove the torque shaft by prying the shaft out of the plastic grommet on the transmission side. Inspect the plastic grommet for any signs of
damage and replace as required.
6.
Clean the torque shaft and grommets and apply a coating of grease, p/n 04318063 or equivalent, to the torque shaft in the area that the grommets
and spring will sit.
7.
Instal the new spring, p/n 05101852AA, over the shaft as shown (Fig. 1) and insert the end of the shaft into the plastic grommet.
8.
Install the torque shaft attaching screws and tighten them to 30 Nm (300 in.lb.).
9.
install the gear shift rod vertical link into the grommet.
10.
Lower the vehicle and ensure that the gear shift link is adjusted properly 3nd that the gear indicator (PRNDL) on the instrument panel is reading
correctly. Adjust the shift linkage and/or the indicator cable as required.
POLICY:
Reimbursable within the provisions of the warranty.
TIME ALLOWANCE:
FAILURE CODE:
