RAM 2500 Truck 4WD V10-8.0L VIN W HDC (2000)
1.
Inspect the new separator plate p/n 52118048AB. The correct plate will have a 3 mm (0.118 inch) wide slot at the torque converter clutch lock-up
vent circuit (Figure 1).
NOTE:
VERIFY THAT THE SLOT SHOWN IN FIGURE 1 IS APPROXIMATELY 3 MM (0.118 IN.) WIDE. THE SEPARATOR PLATE IS
INCORRECT IF THE SLOT IS APPROXIMATELY 12 MM WIDE.
2.
Clean the separator plate to remove any dirt or rust inhibitor prior to installation.
3.
Replace the transmission valve body upper housing separator plate and the transmission oil pan gasket (p/n 05012978M). Refer to the appropriate
year Service Manual, Group 21 - Transmission and Transfer Case for removal and installation instructions for the transmission valve body and its
upper housing separator plate.
4.
Verify fluid level after warming up the transmission and cycling the shift lever several times.
5.
Verify, and if required, adjust the transmission shift linkage and the transmission throttle valve cable per the appropriate Service Manual
procedures.
POLICY: Reimbursable within the provisions of the warranty.
TIME ALLOWANCE:
FAILURE CODE: P8 - New Part
