RAM 2500 Truck 4WD V10-8.0L VIN W HDC (2000)
Transfer Case Shift Boot: Service and Repair
4WD FLOOR SHIFT BOOT
REMOVAL
Fig. 2
1. Using a small pry bar or equivalent, remove the insert, the nut and remove the shifter knob. (Fig. 2)
Fig. 1
2. Using a trim stick C-4755 or equivalent, pry up the boot from the console. (Fig. 1)
INSTALLATION
1. Position the shift boot over the shifter lever fully seat onto the console.
2. Install the shifter knob and nut and tighten to 27 N.m (20 ft.lbs).
3. Position the insert and seat into the knob fully.
