RAM 2500 Truck 4WD V8-5.2L VIN Y (2000)
If equipped with A/C, the generator and A/C compressor along with their common mounting bracket must be partially removed. Removing the
generator or A/C compressor from their mounting bracket is not necessary. Also, discharging the A/C system is not necessary. Do not remove any
refrigerant lines from A/C compressor.
WARNING: THE A/C SYSTEM IS UNDER PRESSURE EVEN WITH THE ENGINE OFF. REFER TO REFRIGERANT WARNINGS IN
HEATING AND AIR CONDITIONING.
1. Disconnect negative battery cable from battery.
2. Partially drain cooling system.
2. Do not waste reusable coolant. If the solution is clean, drain the coolant into a clean container for reuse.
3. Remove upper radiator hose clamp at radiator. A special clamp tool must be used to remove the constant tension clamps. Remove hose at radiator.
4. Disconnect throttle cable from clip at radiator fan shroud.
5. Unplug wiring harness from A/C compressor.
6. Remove the air cleaner assembly.
7. Remove accessory drive belt. Refer to Engine, Drive Belts, Mounts, Brackets and Accessories.
8. 3.9L V-6 or 5.2/5.9L V-8 LDC-Gas: The drive belt idler pulley must be removed to gain access to one of the A/C compressor/generator bracket
mounting bolts. Remove the idler pulley bolt and remove idler pulley.
