RAM 2500 Truck 4WD V8-5.2L VIN Y (2000)
Headlamp Bulb: Service and Repair
On driver side and on vehicles with dual batteries, the headlamp assembly must be removed to service the headlamp bulb.
REMOVAL
1. Release hood latch and open hood.
2. To remove headlamp assembly on drivers side or passenger side when equipped with dual batteries, refer to Headlamp Removal of Exterior
Lamps.
3. Disengage wire connector from headlamp bulb(s).
Headlamp Bulb
4. Remove retaining ring holding bulb(s) to headlamp.
5. Pull bulb(s) from headlamp.
INSTALLATION
CAUTION: Do not touch the bulb glass with fingers or other oily surfaces. Reduced bulb life will result.
1. Position bulb(s) in headlamp.
2. Install retaining ring holding bulb(s) to headlamp.
3. Connect wire connector to headlamp bulb(s).
