RAM 2500 Truck 4WD V8-5.2L VIN Y (2000)
If equipped with a 35 gallon fuel tank, two rollover valves are also used, but both valves are permanently mounted to top of fuel tank (Fig. 21). If
replacement is necessary, fuel tank must be replaced.
1. Disconnect negative battery cable at battery.
2. Remove fuel filler cap and drain fuel tank.
3. Remove fuel tank.
4. Disconnect tube (line) at valve.
5. The rollover valve is seated into a rubber grommet. Remove valve by prying one side upward and then roll valve out of grommet.
6. Discard old grommet.
INSTALLATION
1. Install new grommet into fuel pump (or fuel tank) module.
2. Using finger pressure only, press valve into place.
3. Install fuel tank. Refer to Fuel Tank Installation.
4. Fill fuel tank. Install fuel tank filler cap.
5. Connect negative battery cable(s).
6. Start vehicle and check for leaks.
